• slider1.jpg
  • slider2.jpg
  • slider3.jpg
  • slider25.jpg

Type Test Equipment

General Information

Manufacturers and users have expressed the need for type testing at a European level. For that reason EUREF decided to organise and standardise type testing for mammography systems at the European level. The standards applied in the EUREF type testing are based on chapter two of the fourth edition of the European Guidelines. This chapter can be found in the download section of this website.

EUREF type testing is defined as a test (1) to verify whether a type of system is able to pass the acceptability criteria of the European protocol, (2) to provide guidelines about the best practice in terms of dose and (clinical) image quality. After a successful type test, individual mammography units of the same and type brand still need to undergo an acceptance test before clinical use. Passing the type test only guarantees that the system is in principle capable of meeting the requirements of the European Protocol and the report may list suggestions for optimal use or conditions to be avoided in practice.

EUREF type tests are currently performed on digital mammography units (DR and CR systems). In future EUREF type testing may be performed on image processing algorithms, workstations and film digitisers.

Latest news

Updated version of European breast tomosynthesis QC protocol (version 1.01)

Due to the rapid developments the European breast tomosynthesis protocol (version 1.01) has been updated and released.

 

Changes compared to version 1.0:

  • Table 1 has been updated.
  • For scanning geometry DBT systems inherently without projection images it has been mentioned in the description of several measurements that the simple backprojection mode should be used.
  • In the terms of definition the reference ROI in simple backprojection images has been added.
  • In the dosimetry section the s-factor for Rh/Ag has been added.
  • Some small errors has been corrected.

 

Download the updated version here (bottom of the page).

Workshop on quality control in breast tomosynthesis in Vienna on September 11th, 2015

In this workshop the physic-technical steering group will give an overview on breast tomosynthesis systems, provide insights of the why’s of measurements, will give practical tips for QC measurements and explain the software which is made available by the centres who participated in drafting the protocol.

 

More information can be found here.

© 2017 EUREF  |  Terms and Conditions EUREF  |  webdesign by Joomla webdesign